Enter New Total Operational Values
Explanation
This activity is used to enter any operational values that have previously
been performed on a serial structure but not yet been logged in the system. It
is possible not only to enter new values for the structure as a whole, but also
give individual nodes or branches in the serial structure other values than the
top, in the case where parts of the structure have a differing history from the
configurations they are currently mounted into.
To adjust recently added values, ensure that the recorded date is exactly the
same as for the record(s) you want to update. Then in the Add On Value
field for a record, enter the difference between the earlier entered value and
the correct value, and save. The value entered in the Add On Value field
will then be added to the value already in history.
Note that if a serial is registered in the application on a later date than
the last performed archiving, it will be possible to enter loggings prior to the
archiving date from the
Component Life/Operational Log
tab. This implies that no archiving has been performed after the serial was
created.
Prerequisites
- A serial defined to be either life limited or not
life limited must exist.
- Operational parameters must have been set up and made active
for the part.
System Effects
- Records are updated as if it had been recorded
through ordinary operational logging.
- The entered operational parameter values will be
validated against the time of execution and the values entered on any
previous or later loggings.
- A record is added to the operational history for the
serial.
- For all life limited serials the consumed life is
updated with the new values.
Window
Component Life
Related Window Descriptions
Component Life/Operational Log
Procedure
- Open the
Component Life window, and query for a
serial structure.
- In the
Component Life/Operational Log
tab,
observe the operational parameters that are automatically populated. If the
Spread On Branch check box is selected, operational parameters valid for all
serials in the structure will be displayed.
- For the operational parameter to be logged, enter the
operational value either as an add-on value or new total value.
- Repeat step 3 for other operational parameters to
be logged.